食品科学 ›› 2009, Vol. 30 ›› Issue (20 ): 231-233.doi: 10.7506/spkx1002-6300-200920048

• 工艺技术 • 上一篇    下一篇

喷雾干燥与冷冻干燥玉米肽工艺的比较研究

文连奎1,冯永巍1,郭 平2,李鸿梅1   

  1. 1.吉林农业大学食品科学与工程学院  2.吉林大学 分子酶学工程教育部重点实验室
  • 收稿日期:2009-07-05 出版日期:2009-10-15 发布日期:2010-12-29
  • 通讯作者: 文连奎1 E-mail:wenliankui@163.com

Comparison of Freeze Drying and Spray Drying for Corn Peptides

WEN Lian-kui1,FENG Yong-wei1,GUO Ping2,LI Hong-mei1   

  1. (1. College of Food Science and Engineering, Jilin Agricultural University, Changchun 130118, China ;2. Key Laboratory of
    Molecular Enzymology and Engineering, Ministry of Education, Jilin University, Changchun 130021, China)
  • Received:2009-07-05 Online:2009-10-15 Published:2010-12-29
  • Contact: WEN Lian-kui1 E-mail:wenliankui@163.com

摘要:

以酶解法制备的玉米肽为原料,对其冷冻干燥和喷雾干燥的工艺进行研究。确定冷冻干燥条件为预冷温度-30℃,预冷时间2h;加热温度从-10℃开始18h后缓慢升温,达到25℃,并保持到干燥终点。喷雾干燥的最佳工艺参数为进风温度180℃,进样速度为30ml/min,离心雾化器转速为20000r/min。并对两种干燥方法制得产品的理化特性进行了比较。

关键词: 玉米肽, 冷冻干燥, 喷雾干燥

Abstract:

In order to obtain optimal technological processing for drying of corn peptides, comparison between freeze drying and spray drying was conducted to use corn peptides prepared by enzymatic hydrolysis as materials. Results indicated the optimal processing parameters of freeze drying were -30 ℃ of pre-treatment temperature, 2 h of pre-treatment time, initial heating from -10 ℃ with a gradient temperature increase for 18 h, final temperature at 25 ℃ until the end-point of drying. On the other hand, the optimal processing parameters for spray drying were 180 ℃ of inlet temperature, 30 ml/min of flux rate and 20000 r/min of rotating speed. Physicochemical properties of corn peptides using both drying methods were also compared. Although no obvious difference on physicochemical properties of corn peptides dried by both methods was observed, spray drying technology is catachrestic of low cost and high productivity. 

Key words: corn peptides, spray drying, freeze drying

中图分类号: